Design your own fig
2 posts
• Page 1 of 1
Design your own fig
by Darkson (Simon) » Thu May 28, 2015 7:42 pm
Send help - buried under my lead mountain!
-
Darkson (Simon) - Archduke Pumpkin of ARBBL
- Posts: 4707
- Joined: Fri Jun 27, 2014 3:34 pm
Re: Design your own fig
by Darkson (Simon) » Fri Jul 06, 2018 4:47 pm
Bumping this.
I'm considering looking at this again to see if I can make a club-member only figure. In the past I was put off my cost (and ease) of getting figures made, but I now know of a printer that can produce them at a reasonable price and good quality.
Works out at $10 for the file, $5 per figure and a flat $15 shipping.
If anyone else wants to give it a go feel free.
I'm considering looking at this again to see if I can make a club-member only figure. In the past I was put off my cost (and ease) of getting figures made, but I now know of a printer that can produce them at a reasonable price and good quality.
Works out at $10 for the file, $5 per figure and a flat $15 shipping.
If anyone else wants to give it a go feel free.
Send help - buried under my lead mountain!
-
Darkson (Simon) - Archduke Pumpkin of ARBBL
- Posts: 4707
- Joined: Fri Jun 27, 2014 3:34 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests